Hinkley-lighting BROADWAY FR41437PAL Manuel d'utilisateur télécharger pdf

fR41437PAL

BROADWAY

A S S E M B LY I N S T RU CTION S

Assembly of this ﬁxture will be accomplished by ﬁrst determining the length of stem

required, attaching the mounting strap to the junction box, making all necessary

electrical connections, hanging the ﬁxture from the ceiling and then installing the

ﬁxture glass.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply oﬀ during installation. If new wiring

is required, consult a qualiﬁed electrician or local authorities for code requirements.

STEP 1

1 Determine the overall length you will need the assembled ﬁxture to be.

2 Determine what stems will be needed to achieve the overall length you

require.(Additional stems are available and can be ordered. Ask your local

Fredrick Ramond representative or visit www.fredrickramond.com for

information.

3 Install stems by slipping them onto the supply wire of the ﬁxture, threaded end up,

and threading them together.

STEP 2

STEP 3

1 To lamp ﬁxture remove glass retainer ring (2) from main body (1). NOTE: the glass

retsiner ring is held in position by spring tension and can be easily removed by pulling

ﬁrmly on the edge at the split line. Retainer ring is attached to the ﬁxture by a wire

cable and will not fall when released - See Drawing 2.

Lamp ﬁxture with bulbs provided and replace retainer ring by snapping in back in place.

1 Glass is held in glass retainer ring by a “C” shape spring ring (r). To remove, replace, or install glass

it is necessary to pinch the two short tabs (t) of the ring together, after glass is installed ring

can be replaced in same manner -see Drawing 3.

[DRAWING 1]

[DRAWING 2]

Bulbs: 60W g-9. Replacement Parts: GLASS: R41430GL

06.01.11

4 After all stem lenghts required are assembled, slip wire through center of canopy swivel,

slip canopy assembly along wire and thread into top of last stem. Fixture is ready for

installation.

1 Attach mounting plate (a) to junstion box (j) with screws provided -See Drawing 1

2 Make all wiring connections following instruction sheet (FRIS 18) provided.

Please follow all necesary precautions.

3 After all connections are made, slip canopy (c) over mounting plate (a) and hold

in poistion while tightening screws (d). NOTE: As screws (d) are tighten canopy

will move upward and be ﬂush against the ceiling.

4 Installation is complete and ﬁxture can now be lamped.

STEP 4

[DRAWING 3]

BROADWAY 1

Résumé du contenu

Page 1 - BROADWAY

fR41437PAL BROADWAYA S S E M B LY I N S T RU CTION S Assembly of this ﬁxture will be accomplished by ﬁrst determining the length of stem required

Commentaires sur ces manuels

Pas de commentaire

Hinkley-lighting BROADWAY FR41437PAL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Hinkley-lighting BROADWAY FR41437PAL. Hinkley Lighting BROADWAY FR41437PAL User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Hinkley-lighting BROADWAY FR41437PAL