Hinkley-lighting DRAKE 1991 Manuel d'utilisateur télécharger pdf

assembly instructions

Family: Drake Item No. 1991

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

*** The construction of this ﬁxture will be accomplished by ﬁrst assembling the

main body of the ﬁxture, making all necessary electrical connections, mounting

the ﬁxture to pre-installed post, and then installing the glass.

start here

Drawing 1 - Fixture Mounting

1991

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet 18 (I.S. 18) and follow instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

1. After wiring connections are complete, slip post ﬁtter (A) over top of pre-installed

post (B)making sure all wire connections are tucked inside the pole - see Drawing 1.

2. When ﬁxture is slipped over pole make sure no wires are being pinched between the

top edge of the pole and the inside of the post ﬁtter.

3. Thread the 3 set screws (C) into pre-tapped holes in post ﬁtter.

4. Tighten screw (C) to secure ﬁxture to post.

06.01.13

1. To lamp ﬁxture remove screw (1) located under roof (2) lip. After screws are remove

roof (2) can be removed from cage (C), ﬁxture can now be lamped accordingly -see

Drawing 2.

2. To replace a glass panel (5), remove screw (1) located under the roof lip. Lift roof (2)

off of cage (C).

3. Remove screw (3) holding the glass clip (4) in place.

4. Remove broken glass and slip new piece into place. Making sure bottom of glass ﬁts

behind the tabs located in the bottom of the cage.

5. Replace glass clip (4) and thread screw (3) back into place to secure glass.

6. Replace roof (2) and secure with screws (1) removed earlier.

Drawing 2 - Glass Replacement

HINKLEY LIGHTING 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

Résumé du contenu

Page 1 - Drawing 2 - Glass Replacement

assembly instructionsFamily: Drake Item No. 1991 1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. Carefully re

Page 2

HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.comI.S. 18 wiring grounding instr

Commentaires sur ces manuels

Pas de commentaire

Hinkley-lighting DRAKE 1991 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Hinkley-lighting DRAKE 1991. Hinkley Lighting DRAKE 1991 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Hinkley-lighting DRAKE 1991