Hinkley-lighting MIME FR45608BNI Manuel d'utilisateur télécharger pdf

FR45608BNI/FBZ

MIME

ASSEMBLY I N STRUC T IONS

Assembly of this ﬁxture will be accomplished by ﬁrst assembling the main body,

installing the mounting hardware to the junction box, hanging the ﬁxture and then

installing the shade and crystals.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply oﬀ during installation. If new wiring

is required, consult a qualiﬁed electrician or local authorities for code requirements.

STEP 1

See Drawing 1.

STEP 2 Refer to Hanging Instruction Sheet [FRIS19] to hang ﬁxture. Then refer

back to this sheet to continue installation of this ﬁxture.

STEP 3

[DRAWING 1]

Bulbs: 6-60W CAND. Replacement Parts: SHADE: R45608SH (BNI FINISH),

R455608AMBSH ( fbz FINISH),

R45602CRY-A

01.01.13

Slip center ring (1) along wire and between arms (2). Line up holes in ring

to holes in arms.

Slip ball knob sutd (3) through arm and thread into ring (1).

Slip center column (4) along wire and through ring (1) and thread onto top

of main body (a).

Slip loop (5) along wire and thread onto top of ﬁxture.

Spread arms (b) until they are 90 degrees apart.

Fixture is ready for installation.

Take shade (7) and line up holes in tabs (d) with the holes in

end of arms (b). Shade tab shold be on top of the arm.

Slip ball knob stud (8) throgh hole in arm and thread it into shade

tab. Repeat process with the remaining arms.

Thread ﬁnial (9) onto threaded tube (t) at bottom of ﬁxture.

Attach crystals (10) at areas (e) indicated.

FR45608BNI/FBZMIMEASSEMBLY I N STRUC T IONS Assembly of this ﬁxture will be accomplished by ﬁrst assembling the main body, installing the mounti

Modèles reliés MIME FR45608FBZ

Pas de commentaire