Hinkley-lighting MONTREAL 1731AI Manuel d'utilisateur télécharger pdf

assembly instructions

Family: Montreal Item No. 1731 AI

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. Slip candle sleeve (1) over socket (2) - see Drawing 1.

1. Fixture can now be lamped accordingly.

2. Thread center stem (3) into top of candle cluster - see Drawing 1.

3. Slip glass (4) over center stem (3), followed by decorative cap (5) and crown (6).

4. Thread knob (7) onto center stem (3) and tighten.

*** The construction of this ﬁxture will be accomplished by ﬁrst assembling

main body of the ﬁxture, making all necessary electrical connections, mounting

the ﬁxture to pre-installed post and then installing the glass.

start here

1731

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Note: Maximum wattage for 1731 ﬁxture is 60 watts per bulb.

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

Drawing 2 - Fixture Mounting

Drawing 1 - Fixture Assembly

1. After wiring connections are complete, slip post ﬁtter (A) over top of pre-installed

post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.

2. When ﬁxture is slipped over pole make sure no wires are being pinched between

the top edge of the pole and the inside of the post ﬁtter.

3. Thread the 3 set screws (C) into pre-tapped holes in post ﬁtter (A).

4. Tighten set screws (C) to secure ﬁxture to post (B).

1. Fixture is mounted using 3 - 1/4-20 set screws.

2. Make all necessary electrical connections following wiring instructions below.

3.16.09

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

assembly instructionsFamily: Montreal Item No. 1731 AI 1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. Caref

Page 2

I.S. 18 wiring grounding instructionsSAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPL

Pas de commentaire

Hinkley-lighting MONTREAL 1731AI Manuel d'utilisateur