Hinkley-lighting NEST FR41613ORB Manuel d'utilisateur télécharger pdf

FR41613ORB

NEST

ASSEMBLY INSTRUCTIONS

Assembly of this ﬁxture will be accomplished by ﬁrst assembling the main body,

installing the mounting hardware to the junction box, making all necessary electrical

connections, hanging the ﬁxture from the ceiling and then installing the ﬁxture glass.

SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]

and any additional directions. Turn power supply oﬀ during installation. If new wiring

is required, consult a qualiﬁed electrician or local authorities for code requirements.

STEP 1

1 Slide yoke (b) along wire and slip studs (1) through holes in top of cross bar (2),

making sure not to pinch any wires during the process.

2 Thread barrel nuts (c) onto end of studs (1) and tighten.

STEP 2 Refer to Hanging Instruction Sheet [FRIS19] to hang ﬁxture.

STEP 3

1 Prior to installing glass, ﬁxture can now be lamped accordingly.

2 To install glass, thread center tube (d) into coupler (3) approximately 3/8”.

3 Slip glass (e) onto center tubing (d) and hold in position.

4 Slip cap (f) onto center tubing (d) and hold in position.

5 Thread hex nut (g) onto center tube (d) and tighten to secure glass (e).

6 Slip bottom cap (h) onto center tube (d) and hold in position.

7 Thread barrel cap (i) onto end of center tube (d) and tighten to secure parts.

[DRAWING 1]

Bulbs: 100W MED. Replacement Parts: GLASS: R41613GL

6.22.09

800.421.3517 WWW.FREDRICKRAMOND.COM

Page 1

FR41613ORBNEST ASSEMBLY INSTRUCTIONS Assembly of this ﬁxture will be accomplished by ﬁrst assembling the main body, installing the mounting hard

Pas de commentaire

Hinkley-lighting NEST FR41613ORB Manuel d'utilisateur