Hinkley-lighting ANNA 5782 Manuel d'utilisateur télécharger pdf



assembly instructions

Family: Anna Item No. 5782 CM/SE

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. Remove mounting plate (1) from ﬁxture backplate (5) by removing the 4 ﬂathead

screws (4) - see Drawing 1.

2. Take main mounting plate (1) and slide the wires from the junction box through the

large center hole. Line up the curved slots (3) with the threaded holes in the junction

box. Using 2 screws (2) attach the main mounting plate to the junction box.

• Make sure mounting plate tabs are 90 degrees to the ceiling line - see Drawing 2.

1. Mount the ﬁxture by sliding the backplate (5) over the mounting plate (1) - see

Drawing 1.

2. Attach the backplate (5) to the ﬁxture using the screws (4) that were removed prior.

1. To install glass, remove threaded socket ring (C) from socket (A) - see Drawing 3.

2. Place glass (B) over exposed section of socket (A).

3. Thread socket ring (C) onto socket (A) to secure glass (B).

4. Repeat steps 1-3 for remaining glass.

5. Fixture can now be lamped accordingly.

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting strap to the junction box, making all necessary electrical connections,

mounting the ﬁxture to the wall, and then installing the ﬁxture glass.

start here

5782

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.



Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

Drawing 1 - Fixture Mounting

Drawing 2 - Mounting Plate

Drawing 3 - Glass Installation

ceiling line

ﬁxture

plate

90°

2223

2.7.08

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

Résumé du contenu

Page 1 - Drawing 2 - Mounting Plate

assembly instructionsFamily: Anna Item No. 5782 CM/SE1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. Carefu

Page 2

I.S. 18 wiring grounding instructionsSAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPL

Commentaires sur ces manuels

Pas de commentaire

Hinkley-lighting ANNA 5782 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Hinkley-lighting ANNA 5782. Hinkley Lighting ANNA 5782 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Hinkley-lighting ANNA 5782