Hinkley-lighting MONTAUK 1201 Manuel d'utilisateur télécharger pdf

assembly instructions

Family: Montauk Item No. 1201

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting strap to the junction box, making all necessary electrical connections,

mounting the ﬁxture to the wall, and then lamping the ﬁxture .

start here

1201

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet

Drawing 3 - Fixture Assembly

(I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

Drawing 2 - Fixture Mounting

1.01.12

Drawing 1 - Glass Installation

1. To install glass, slip glass panel (1) into the cage assembly (2) - see

Drawing 1.

2. Slip top of glass panel (1) under top glass clips (3).

3. Slip bottom of glass panel (1) into the bottom of the cage assembly (2).

4. Bend lower glass clips (4) up to retain glass panels (1).

5. Repeat steps 1-4 for remaining panels.

1. After wiring connections are complete, slip post ﬁtter (A) over top of pre-installed

post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.

2. When ﬁxture is slipped over pole make sure no wires are being pinched between

the top edge of the pole and the inside of the post ﬁtter.

3. Thread the 3 set screws (C) into pre-tapped bushings in post ﬁtter.

4. Tighten screws (C) to secure ﬁxture to post.

1. After mounting main xture body to the post, xture can be lamped accordingly.

2. Attached roof of xture by slipping studs (6) through holes (7) of cage assembly.a

3. Thread ball knobs (8) onto end of studs and tighten to secure cage assembly to

xture body. Fixture is complete.

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

1 2

Résumé du contenu

Page 1 - Drawing 2 - Fixture Mounting

assembly instructionsFamily: Montauk Item No. 1201 1. Find a clear area in which you can work.2. Unpack ﬁxture and glass from carton.3. Careful

Page 2

I.S. 18 wiring grounding instructionsSAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPL

Commentaires sur ces manuels

Pas de commentaire

Hinkley-lighting MONTAUK 1201 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Hinkley-lighting MONTAUK 1201. Hinkley Lighting MONTAUK 1201 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Hinkley-lighting MONTAUK 1201